Paradyne 3810 manual Placing Modems into Talk Mode Once Modems Are Online, Idle Tlk/Data Status

COMSPHERE 3800 Series Modems

Manual Dialing when the Remote Modem Is Configured for Auto-Answer

If you are originating a call using a telephone and the remote modem is configured for Auto-Answer, perform the following procedure.

Idle : 19.2

Tlk/Data Status

F1 F2 F3

Press the key until Tlk/Data is displayed.

Lift the attached handset and dial the telephone number of the remote modem. When the remote modem answers, it transmits an answer tone.

Idle : 19.2

Tlk/Data Status

F1 F2 F3

When you hear this tone, immediately select Tlk/Data. This starts the handshaking sequence between your modem and the remote modem.

Online : 19.2 >

Call_Setup

F1 F2 F3

If this is successful, the modems are in Data mode and Online appears on the LCD.

Manual Dialing when the Remote Modem Is Configured for Manual Answer

If you are originating a call using a telephone and the remote modem is configured for Manual Answer, perform the following procedure.

Once the remote telephone is answered by the remote user, you must both decide when to place the modems into Data mode. You must both select Tlk/Data at approximately the same time to begin the handshaking sequence.

If the handshake is successful, the modems are in Data mode and OnLine appears on the LCD.

NOTE

If the remote modem is not a 3800 Series modem, then the remote user must consult that modem's operator's manual to perform a similar operation.

Once the modems are online, status messages listed in Table 4-4 in Chapter 4 appear on the Top-Level display.

It is not necessary to specify an originating or answering modem when dialing via the DCP because the answering modem remembers that it received a ring voltage and will automatically default to Answer mode.

Placing Modems into Talk

Mode Once Modems Are Online

If you want to communicate to a remote user via the telephone once a dial connection has been established, perform the following procedure.

Via your asynchronous DTE, inform the remote user that you wish to talk and will be placing the modems into Talk mode. Both users should perform the following.

1.Lift the handset.

2.Press the key until Tlk/Data is displayed.

3.Select Tlk/Data.

The telephones are now connected and you are able to talk to the remote user. When you finish your conversation, and return to Data mode, both of you must select Tlk/Data.

4.Place the handset on to the cradle.

6-2 November 1996 3810-A2-GB30-20