Paradyne 3810 manual Series S-Registers Description Front Panel Branch

COMSPHERE 3800 Series Modems

Table 14-2

(1 of 11)

3800 Series S-Registers

S-Register	Description	Front Panel Branch
S0	Auto-Answer Ring Number	Configure\Edit\Line Dialer
	Register determines number of rings the modem will count before
	automatically answering a call.
	Enter zero (0) if you do not want the modem to automatically answer any
	calls. Otherwise, enter a value from 1 to 255 for the number of rings to
	count before answering.
	Factory setting is 1.
S2	AT Escape Character	Configure\Edit\DTE Dialer
	Register determines ASCII value used for escape sequence to enter
	Command mode from Data mode.
	Enter a value from 1 to 127 for the escape character. Any value greater
	than 127 causes the modem to disable the escape sequence. When the
	escape sequence is disabled, the modem cannot return to Command
	mode until the call is disconnected.
	Factory setting is 43 (+ key).
S3	Carriage Return Character	Configure\Edit\DTE Dialer
	Register determines ASCII value used as the carriage return (Return
	key). This character is used to end command lines and result codes.
	Enter a value from 0 to 127 for the command end character.
	Factory setting is 13 (carriage return key).
	NOTE: The &W command used to save this change must be on a
	separate line. This ensures both that the change is intentional,
	and that the DTE can enter the new character.
S4	Line Feed Character	Configure\Edit\DTE Dialer
	Register determines ASCII value used as the line feed character.
	Enter a value from 0 to 127 for the line feed character.
	Factory setting is 10 (ASCII carriage return or line feed).
S5	Backspace Character	Configure\Edit\DTE Dialer
	Register determines ASCII value used as the backspace (Backspace
	key). This character moves the cursor to the left and erases the previous
	character.
	Enter a value from 0 to 127.
	Factory setting is 08 (backspace key).
S6	Blind Dial Pause	Configure\Edit\Line Dialer
	Register determines how long (in seconds) the modem waits after going
	off-hook before dialing a telephone number if using result code X0, X1,
	or X3.
	Enter a value from 2 to 255 seconds.
	Factory setting is 2 seconds.
S7	No Answer Timeout	Configure\Edit\Line Dialer
	Register determines how long (in seconds) an originating modem waits
	before abandoning a call when no answer tone is received.
	Enter a value from 1 to 255 seconds.
	Factory setting is 45 seconds.

14-16 November 1996 3810-A2-GB30-20