Paradyne 3810 DTR Cont Repeat, Receive Buffer Disconnect Delay, Auto Make Busy, Dial-Line Rate

AT Command Set and S-Registers

S-Register

Table 14-2

(4 of 11)

3800 Series S-Registers

Description Front Panel Branch

S38	DTR Cont Repeat				Configure\Edit\DTE_Dialer
	Determines whether automatic dialing of dial backup directory locations
	will be repeated continuously, or halted after the first pass.
	Regardless of the setting of S38, dialing is locked out after ten failed
	attempts to connect to the same number.
	Register has the following values:
	0 = Disable
	1 = Enable
	Factory setting is Disable.
S39	Receive Buffer Disconnect Delay				Configure\Edit\
	Determines the maximum amount of time the modem can continue to				V42/MNP/Buffer
	send data in its Receive Buffer to the DTE after the modem is
	commanded by the DTE to disconnect, or after the modem detects a line
	disconnect.
	Register has the following values:
	S39 = 0		Disable (Immediate disconnect)
	S39 = 1		1 second
	S39 = 2		2 seconds
	S		S	S
	S		S	S
	S39 = 255 255 seconds
	Factory setting is Disable (0).
S40	Auto Make Busy				Configure\Edit\Line Dialer
	Register determines if the modem goes off-hook under certain
	conditions. This register should only be enabled when the modem is
	located behind a user's Private Branch Exchange (PBX). This register is
	only valid for Model 3811 modems.
	Register has the following values:
	0 = Disable
	1 = Enable
	Factory setting is Disable.
S41	Dial-Line Rate				Configure\Edit\Dial Line
	Register determines the modem's data rate and modulation scheme for
	operation on dial lines.
	Register has the following values:
	1	=	4400 (V.32bis)
	2	=	12,000 (V.32bis)
	3	=	9600 (V.32bis/V.32)
	4	=	7200 (V.32bis)
	5	=	4800 (V.32bis/V.32)
	6	=	2400 (V.22bis)
	7	=	1200 (V.22)
	8	=	1200 (212A)
	10	=	0±300 (V21)
	11	=	0±300 (103J)
	20	=	19,200 (V.32terbo)
	21	=	16,800 (V.32terbo)
	Factory setting is 19,200 (V.32terbo).

3810-A2-GB30-20 November 1996 14-19