Paradyne 3810 manual Call Disconnect Indicates Messages, Call Failure

DCP Operation

	Table 4-4
	(2 of 3)
	Top-Level Menu Status
Call Failure	Indicates
Messages
Busy Signal	The answering modem is busy.
Dial Line in Use	The modem is already operating on dial networks when another call attempt has been issued.
Invalid Number	The modem has dialed a telephone number not stored in a directory location.
No Answer Tone	The answering modem has not answered within the time limit specified by the No Answer
	Timeout configuration option.
No Dial ± DTR	The modem cannot dial because DTR is Off.
No Dial ± Test	The modem cannot dial because it is running a Test.
No Dial Tone	The modem has aborted the call because it cannot detect a dial tone.
No Quiet Answer	The modem has detected No Quiet Answer (@) before the time-out setting of the No Answer
	Disconnect configuration option.
Trunk Busy	The modem is receiving a fast (trunk) busy.
Call Disconnect	Indicates
Messages
ATH Disconnect	The modem has disconnected due to an ATH command.
Bad Lines Disc	The modem has disconnected because the lines do not support the modulation and/or data rate
	selected.
No Carrier Disc	The modem disconnects due to the loss of carrier signal from the remote modem.
DTR Disconnect	The modem has disconnected due to the loss of DTR from the DTE.
EC Disconnect	The modem has disconnected due to failure to negotiate Error Control mode.
Inv Rate Disc	When using V.32bis modulation, the remote modem does not support the data rate used by the
	local modem.
LnCurrnt Disc	The modem has disconnected due to the loss of line current.
LongSpace Disc	The modem has disconnected due to the detection of a long space.
NoData Disc	The modem has disconnected due to a lack of transmitted and received data.
Disconnecting	The modem has begun the disconnect sequence.
Rmt Cmnded Disc	The modem has disconnected due to a V.32 Cleardown received from the remote modem.
Talk Mode	The modem is in Talk mode.

3810-A2-GB30-20 November 1996 4-9