Paradyne 3810 manual Menu Structure, Keys

DCP Operation

Key

The key moves you up one level in the menu tree.

and Keys

Use the and keys to move the viewing window left or right and to scroll the remaining branches and selections into view. A maximum of three selections can be displayed at one time.

These keys also allow you to move the cursor one character to the left or right on data entry displays; for example, to allow entry of one digit at a time.

F1, F2, F3 Keys

Function keys select the LCD choice that appears above the function key; they are labeled F1, F2, and F3. If a selection spans more than one function key, then any of those keys choose that selection.

Select Key (Model 3811 only)

The Select key appears on the optional SDCP of the COMSPHERE 3000 Series Carrier. It is used to connect the SDCP to a modem in a specific slot in the carrier.

Menu Structure

The menu tree is a hierarchical structure used to display functions that configure and control local and remote 3800 Series modems. It is accessed via the DCP and is shown in Appendix A.

The menu tree contains the following branches:

Call Setup	 Used to dial, disconnect, and
	answer telephone calls as well
	as store up to 10 telephone
	numbers in directory locations.
	(See Chapter 5.)

Talk/Data	 Used to switch the modem
	between Talk mode (the
	modem is disconnected from
	the VF line) and Data mode
	(the modem is connected to
	the VF line) when dialing via
	either the DCP or the attached
	telephone. (See Chapter 6.)
Status	 Used to monitor the current
	status of the VF line and DTE
	interface as well as view the
	identity of the modem. (See
	Chapter 7.)
Test	 Used to begin and end various
	modem tests. (See Chapter 8.)
Configure	 Used to change and save the
	modem's configuration
	options. (See Chapter 9.)
Control	 Used to control the modem's
	hardware and software
	functions. (See Chapter 10.)
Remote	 Used to access and control a
	remote 3800 Series modem.
	(See Chapter 11.)
Security	 Used to control the modem's
	dial access security. Appears
	only if the optional security
	feature is installed. (See
	Chapter 12.)

Menu tree branches are described in Chapters 5 through 12. Functions that appear on the LCD vary depending upon the type of model installed, its operating mode, and software configuration.

“Status”

Call_Setup

Tlk/Data

Status

Test

Configure

Control

Remote

Security

494-13083-02

3810-A2-GB30-20 November 1996 4-7