Paradyne 3810 Make Busy Via DTR, Network Position Identification, Network Management Address

COMSPHERE 3800 Series Modems

S-Register

Table 14-2

(9 of 11)

3800 Series S-Registers

Description Front Panel Branch

S69

Make Busy Via DTR

Register determines if the modem goes off-hook (busy) when DTR is Off. Register has the following values:

0 = Disable

1 = Enable

Factory setting is Disable.

Configure\Edit\Line Dialer

S74	Network Position Identification		Configure\Edit\Misc
	Register identifies each modem as either a control or tributary modem.
	Register has the following values:
	0	= Tributary
	1	= Control
	Factory setting is Tributary.
S75	Network Management Address		Configure\Edit\Dial
	Register determines the modem's network address. This address is used
	when accessing the modem from the NMS.
	Enter a value from 0 (network address 001) to 255 (network address
	256).
	Factory setting is 255.
S76	V.32bis Autorate (Dial Line)		Configure\Edit\Dial Line
	Register determines if Autorating is used on dial lines when connected in
	V.32bis mode.
	Register has the following values:
	0	= Enable
	1	= Disable
	2	= Start at 4800 bps
	3	= Start at 9600 bps

Factory setting is Enable.

S77	DTR Alarm Reporting		Configure\Edit\Misc
	Register determines whether an alarm is sent to the 6800 Series
	Network Management System controller when the DTR signal has been
	off for more than 10 seconds.
	Register has the following values:
	0	= Disable
	1	= Enable
	Factory setting is Disable.
S78	V.32bis Automode (Dial Line)		Configure\Edit\Dial Line
	Register allows the modem (when operating on dial lines) to
	automatically detect and connect to the remote modem's modulation
	scheme.
	If the modem is in a modem pool attached to a System 85 Private
	Branch Exchange (PBX), S78 should be set to 2. This modifies
	parameters used during connection to the PBX.
	Register has the following values:
	0	= Enable
	1	= Disable
	2	= System 85
	Factory setting is Enable.

14-24 November 1996 3810-A2-GB30-20