Paradyne manual Model 3830 Installation, Customer- Supplied Equipment

Models: 3830

1 138
Download 138 pages 42.35 Kb
Page 24
Image 24

COMSPHERE 3800 Series Modems ± Model 3830

Two ferrite chokes and cable ties

Fax software and documentation (if fax option installed)

If any hardware components are damaged, notify your service representative. Return equipment using the procedures described in the Government Requirements and Equipment Return section in the front of this book.

Customer- Supplied Equipment

The following customer-supplied equipment is required to complete a data communications system using Model 3830 modem:

A DTE with an available EIA-232-D serial port.

A standard EIA-232-D male-to-female cable with a male DB-25-S connector at one end to attach to the modem.

An ac line cord with an IEC 320 connector and appropriate wall plug if using the 220-240V power transformer.

One of the following modular dial or leased network interfaces:

±RJ11C for dial permissive applications

±JM8 for leased-line applications only

Model 3830 Installation

Before installing your standalone modem, make sure your installation site is clean and well-ventilated. Allow space around the modem for installing cables and telephone cords, and make sure the modem is located within reach of the ac power outlet. The distance between your modem and DTE should be minimized if DTE data rates exceed 19,200 bps. Also, low capacitance cables may be necessary for speeds greater than 19,200 bps or distances greater than 50 feet.

The rear panel of the Model 3830 (Figure 2-1) modem has the following switches and connectors:

An ON/Off power switch.

A 5-pin DIN type power receptacle for ac power transformer.

2-2

August 1998

3830-A2-GB91-30

Page 24
Image 24
Paradyne manual Model 3830 Installation, Customer- Supplied Equipment