
4. AT Command Set and
Table
(16 of 20)
Model 3830 S-Registers
S77 DTR Alarm Reporting
Register determines whether an alarm is sent to the 6800 Series Network Management System controller when the DTR signal has been Off for more than 10 seconds.
Register has the following values:
0 = Disable
1 = Enable
S78 V.32bis Automode (Dial Line)
If enabled, automode permits the modem to automatically connect to a remote modem using any supported modulation scheme.
If disabled, the modem only supports the modulation scheme selected by the S41 register
If the modem is in a modem pool attached to a System 85 Private Branch Exchange (PBX), S78 should be set to 2. This modifies parameters used during connection to the PBX.
Register has the following values:
0 = Enable
1 = Disable
2 = System 85
Factory setting is Enable.
August 1998 |