Polycom VS4000 manual To connect an additional PTZ camera other than PowerCam, Camera 4 Y

Administrator’s Guide for ViewStation EX, ViewStation FX, and VS4000

To connect an additional PTZ camera other than PowerCam:

To a ViewStation FX system: To a VS4000 system:

1.Connect the 7-pin connector end of the 1. Original VS4000: Connect an S-video

Y-shaped PTZ cable to the camera 4			cable to the camera’s S-video connector
port on the rear panel of the system.			and to the system’s Camera 4 S-video
			connector.
Camera 4			Enhanced VS4000: Connect an
			S-video cable to the camera’s S-video
			connector and to an S-video to BNC
			adapter.
2	43		Connect the adapter’s yellow BNC
	1		connector to the camera 4 C connector,
3.3V	7A
12V	3A
2			and the white connector to the camera 4
XVGA
4
2. Connect the 4-pin end of the Y-shaped			Y connector on the VS4000 system’s
			rear panel.
PTZ cable to the S-video connector on		2. Connect a mini-DIN to DB-9 VISCA
the camera.
			cable from the camera’s VISCA IN
3. Connect the 8-pin end of the Y-shaped
			connector to the system’s Camera 4
PTZ cable to the 8-pin VISCA IN port on			control connector.
the camera.
4. Connect the camera’s power pack or							Camera 4 Y
cord to a power outlet.									Camera 4 C
		1							4
									XVGA
		Y
									0101
									5
		C				C
			1	4	2	1	2	3	4
									3
			Camera 4 Control
		3. Be sure the camera’s power switch (if
			any) is off.
		4. Connect the camera’s power pack or
			power cord.
		5. Connect the power cord to a power
			outlet.

For more information about how to connect an additional camera, refer to the setup sheet that came with your system.

2-20 www.polycom.com/videodocumentation