Printronix Network Interface Card Front Panel Message – Dynamically Set Params Read Only, root, reset, telnet, config http on, store tcpip from default config http on

Chapter 5 Unix Troubleshooting Tips

ETHERNET, WLAN

9.At the system prompt, enter:

store tcpip from default config http on

reset

NOTE: This will reset all TCP/IP settings to factory default and reset the NIC.

10.Power the printer off and then back on.

11.Set the IP address, subnet mask, and default gateway parameters to the desired values.

To reset all Integrated NIC TCP/IP values to the factory defaults when access is impossible, contact your Printronix service representative for assistance.

12.If the Web browser access does not work, telnet into the NIC as root. Enter the following command:

config http on

If you are still experiencing difficulty accessing or browsing the printer, contact the Customer Solutions Center for further assistance.

Front Panel Message – Dynamically Set Params Read Only

This is not an error. It is an informational message warning that the IP address has been dynamically set by either dhcp, rarp, or bootp.

To assign a static IP address, turn off the rarp, bootp, and dhcp on the adapter. Use the following procedure:

1.Telnet to the adapter. Login = root, password = (Enter key) Telnet commands are:

store tcpip 1 opts -rarp -bootp -dhcp

save

reset

Wait two minutes for the adapter to reset.

2.Program the IP address, Subnet Mask and Gateway (if required) from the front panel.

154