Printronix Network Interface Card job, user, cksum, email, ioport, set ifc, printer, command, TCP-port, data printed, Job ID, username, etc, about start and finish, the parallel port pins

Chapter 15 Complete Command List

set ifcExample: set ifc <ifnum> updown

Set state of the specified network physical interface up or down. <ifnum> is the interface number for the NIC device.

set logpath <logpath> name <new_name> Example: set logpath l1 name pagecount

Change the current name of the logpath (<logpath>) to a new name as indicated by <new_name>. These names are case sensitive.

set logpath <logpath> type [[-]job] [[-]user] [[-]cksum] [[-]printer] [[-]ioport]

Example: set logpath l2 type job user printer pgcnt

Establish the type of printer and print job logging to be done within this <logpath>. The options are:

job	Job ID, username, etc.
user	User ID along with three messages per job
	about start and finish.
cksum	16-bit checksum value to confirm integrity of
	data printed.
printer	For special printer feedback.
ioport	Printer error messages determined through
	the parallel port pins.

set logpath <logpath> port <TCP-port>emailsyslog Example: set logpath l3 port 2000

Determine where the log information should be sent for a print job or attached printer. The choices are:

TCP-port	TCP port number ranging from 1024 to
	65000.
email	Particular user's email address. This address
	is set using the set sysinfo email
	emailname@IPaddress or
	emailname@domain.com command.

324