Printronix P9000 Series manual Ribbon Life 100% Enable Action, Ribbon Life Analyze JOB

appears on the display. Press MENU DOWN to display ACTION ENABLE. Each time NEXT is pressed at this level, the function will alternate between ENABLE and DISF ABLE. Press ENTER. If the asterisk does not appear, refer to Application Hints on page 9-12.

RIBBON LIFE 100%

ENABLE ACTION *

3.Enter Analyze Job Mode

From the OFFLINE READY display, press MENU DOWN to re-enter the RIBBON LIFE menu. Press NEXT repeatedly until ANALYZE JOB appears on the display.

RIBBON LIFE

ANALYZE JOB

4.Enable Analyze Job Mode

Press ENTER. The message below should appear in the message display. A message to change to a new ribbon will appear if the ribbon was not just changed.

RIBBON LIFE 1000

CHANGE RIBBON

5.Select When Worn Action

From the OFFLINE READY display, press MENU DOWN to re-enter the RIBBON LIFE menu. Enter the WHEN WORN ACTION menu by pressing NEXT until WHEN WORN ACTION appears in the display. Press MENU DOWN, then NEXT repeatedly to select STOP PRINTER action, AUD/VIS ALARM action, or VISUAL ALARM acF tion. The selection will appear in the display with the RIBBON LIFE job rate. Press ENF TER after the desired option appears in the display. If the asterisk does not appear, refer to Application Hints on page 9-12.

RIBBON LIFE 1000

AUD/VIS ALARM *

RIBBON LIFE 1000

VISUAL ALARM *

RIBBON LIFE 1000

STOP PRINTER *

6.Select Ribbon Size

Display if Aud/Vis alarm is chosen

Display if visual alarm is chosen

Display if stop printer is chosen

From the OFFLINE READY display, press MENU DOWN to re-enter the RIBBON LIFE menu. Press NEXT or PREV repeatedly until SET RIBBON SIZE appears on the

RibbonMinder 9-3