Printronix P9000 Series manual Factory Default Configuration Values

Factory Default Configuration Values

Printronix factory default configuration values are shown in Table 3-1. These values are operaF tional when the printer is received. New values can be saved and applied as necessary for each application, but factory default values remain accessible using the LOAD PARAMETERS menu. On the Control Panel Configuration Diagrams, factory configuration values are indiF cated by an asterisk (*). (The asterisk is not shown on the printer display.)

Table 3-1. Printronix Factory Default Configuration Values

Configuration	Factory Default	Configuration	Factory Default
Parameter	Value	Parameter	Value
Forms Length	11.0 Inches	Perforation Skip	Disable
Line Spacing	6 lpi	Paper Out	End of Paper
Print Mode	DP 10 cpi	PMD Fault	Enable
Select Set	IBM PC	Line Width	13.2 Inches
Select Subset	IBM PC Graphics	Host Interface	Centronics
Select Language	ASCII	Parallel Interface:
Ribbon Life	100
		Data Bit 8	Enable
Ribbon Size	60
		PI Line (Dataproducts)	Enable
Job Rate	150
		PI Line (Centronics)	Disable
When Worn Action	Stop Printer
		Data Polarity	Standard
Printer Action	Disable
Printer Protocol	P-Series	Resp. Polarity	Standard
Buffer Size	2048 Characters	Latch Data On	Leading Edge
Printer Select	Disable	Fast Busy (Centronics)	Enable
Paper Advance Switch	Print & Paper Advance	Strobe Polarity	Standard
Power On State	Online
Alarm On Fault	Enable	Serial RS-232 Interface:
Shuttle Timeout	4 Seconds	Data Protocol	X-On / X-Off
		Data Rate	9600 Baud
Unidirectional	Disable
		Word Length	8 Bits
Select SFCC	01 SOH	Stop Bits	One
80-9F Hex	Control Codes	Parity	None
Control Code 08	Double High	Bit 8 Function	Font Select
Control Code 06	8 LPI	CD and DSR	Disable
Overstrike	Enable	CTS and DSR	Disable
Display Language	English	Data Term Ready	Online and BNF
Auto Line Feed	After Full Line	Request to Send	Online and BNF
Define CR Code	CR = CR	Reverse Channel	Online and BNF
VFU Select	EVFU

3-4 Configuration