Printronix P9000 Series manual Line Spacing 1/8 Inch 8 lpi

Line Spacing 1/8 Inch (8 lpi)

	ASCII	Hex	Decimal
P-Series	SFCC LPI;n
	SFCC 0	SFCC 30	SFCC 48
Serial	ESC 0	1B 30	27 48
Purpose	Specifies continuous line spacing at 1/8-inch increments (8 lpi).
Comment	When the 1/8-inch line spacing control code is received, all lines will be
	printed at 8 lpi until a new line spacing is selected or power is reset. The conF

trol code line spacing selection will override the control panel line spacing setF ting and 8 lpi will be reflected on the display when the 6/8 LPI switch is pressed.

	The value of n can be 6 or 8 only. In LPI mode using P-Series printer protoF
	col, if n = 8, this command sets line spacing to 1/8 inch. Values of n other than
	6 or 8 will cause an error message (Command Line Error Messages are listed
	on page 6-3).
Example	The following example illustrates 1/8-inch line spacing.

Programming 6-49