Printronix P9000 Series manual Forms Length Set Lines

Forms Length Set (Lines)

	ASCII	Hex	Decimal
P-Series	SFCC LINES;n
Serial	ESC C n	1B 43 n	27 67 n

Purpose	Sets the length of a form (paper) in lines.
where	n = 1 to 192 (P-Series) or 1 to 127 (Serial) to specify the number of lines
	per page at the current line spacing.
Comment	The forms length set becomes the current forms length. Forms length is deF
	fined in inches; therefore, subsequent line spacing changes do not affect the
	result of this command.
	The forms length is set to the number of lines defined by the quotient of •n"
	and the current line spacing so that the units are in inches. When using the
	ESC C sequence, the quotient of •n" and the current lines per inch cannot
	exceed 113 inches, or an incorrect forms length will result. In LINES mode,
	the maximum form length is 24 inches, and n values in excess of 24 will cause
	an error message (Command Line Error Messages are listed on page 6-3).
	If the calculated forms length in lines is not an exact multiple of the paper step
	distance, the forms length value will be adjusted down to the next possible
	multiple.
	When forms length is set by the ESC C sequence, the skip-over perforation is
	set to zero.
	In P-Series protocol, if the VFU is enabled and loaded, this command is igF
	nored.

Programming 6-43