Paper Stacking Chain Assembly Installation
The Paper Stacking Chain Assembly is used on the printer to ensure correct paper flow and stacking. To install the Chain Assembly, perform the following steps and refer to Figure
1.If paper is loaded in the printer, unload the paper (refer to the Operation chapter).
2.Open the printer rear door to access the paper stacking area.
3.Hook two long chains by their rings to the front of the wire paper guide (toward the front of the printer) and near each outer edge of the paper path. Hook the other two long chains to the rear of the wire paper guide and near each outer edge of the paper path for the paper width used.
4.Hook two of the short chains by their rings to the back of the paper guide and the other two short chains to the front of the paper guide, positioned near the center of the paper path.
5.Refer to the Paper Stacking instructions in the Operation chapter to start the paper stackF ing properly.
Figure 11-3. Chain Assembly Installation
Installation |
|
