A label on the back of the printer near the power cord indicates the voltage and frequency reF quirements. The printer must be connected to the specified power source, either 110, 220 or 240 volts at 50 to 60 Hz. Line voltage can vary 10%. The printer automatically senses and adjusts itself to conform to the proper voltage. Primary circuit protection is contained in the printer. Consult an electrician if printer operation affects local electrical lines.
- WARNING -
The power cord requires an I.E.C. (hot) connector to mate to the receptacle on the rear panel of the printer. The hot connector includes a polarizing key which prevents the use of cordsets that are not of the correct rating for the printer.
- WARNUNG -
Das Stromkabel benötigt einen I.E.C. (spannungsführenden) Stecker, der in die Steckdose an der hinteren Wand des Druckers passt. Der spannungsführende Stecker kommt mit einem Nulleiter, der die Benutzung von Stromkabeln ohne die korrekte Nennleistung für den Drucker verhindert.
Site Requirements
When selecting a printer location, consider interface requirements, power requirements, and environmental factors. Select a location that has the proper power source available and is within the maximum cable length specifications for interfacing with the host computer. The printer is designed to operate in a relatively dust free environment such as a computer room or business office with an ambient temperature of 5_ to 40_ C (41_ to 104_ F) and a relative humidity of 10% to 90%. The site selected for the printer must also allow air to circulate freely all around the printer. A minimum of 3 feet clearance behind the printer should be provided to allow air circulation and easy access to the paper stacking area. Figure
- CAUTION -
The warranty may be voided if adequate printer ventilation is not provided. OverG heating and serious damage to printer components can occur if the air vents at the sides and bottom of the printer are blocked.
- VORSICHT -
Die Gewährleistung könnte ungültig werden, wenn nicht genügen Druckerlüftung vorhanden ist. Überhitzung und schweren Schaden der Druckerkomponenten könnte vorkommen, wenn die Entlüftungsschlitze an den Seiten und unten am Drucker blockiert sind.
Installation |
