Printronix P9000 Series manual Character Set Select Ecma 94 Latin 1 Extended

Character Set Select: ECMA 94 Latin 1 Extended

	ASCII	Hex	Decimal
P-Series	SFCC OSET;n
Serial	N/A	N/A	N/A
Purpose	Selects the Extended Character Set and the print mode and pitch at which the
	extended character will print. Valid only in the ECMA 94 Latin 1 Extended
	Character Set; otherwise, this command is ignored.
Comment	n ranges from 0 to 12 to select the print mode/pitch combinations available
	from Table 6-5. All other values will result in an error message. In OSET
	mode, values outside the range in Table 6-5 will produce an error message
	(Command Line Error Messages are listed on page 6-3).

OSET is valid only when the ECMA 94 Latin 1 character set has been selected from the control panel. OSET will be ignored if the IBM PC, Multinational, or DEC Multinational Character Sets are active.

Extended characters will print at the print mode and pitch selected by the OSET command, even if that mode and pitch differs from the currently seF lected print mode and pitch. If the print mode differs between the extended and primary characters, the first character in the data stream selects the print mode at which that line will print. Different pitches can be printed on the same line.

Table 6-5. Print Modes/Pitches Available Using P-Series OSET

(ECMA 94 Latin 1, Extended Character Set Only)

nPrint Mode/Pitch Select

0Bar Code DP 10 cpi

1Multinational DP 10 cpi

2Multinational DP 12 cpi

3Multinational NLQ 10 cpi

4Greek DP 10 cpi

5Greek DP 12 cpi

6Greek NLQ 10 cpi

7Graphics DP 10 cpi

8Graphics NLQ 10 cpi

9Scientific DP 10 cpi

10Scientific DP 12 cpi

11Scientific NLQ 10 cpi

12Multinational at Primary Character Set Mode and Pitch

Programming 6-27