RAD Data comm ASMi-52 Configuring the Line Interface Type, Configuring the Serial DTE Interface

Chapter 5 Configuring a Typical Application Installation and Operation Manual

2.From the Framed Mode menu, select Unframed to choose the unframed operation.

The E1 Local Port menu appears.

3.Save the changes.

After performing these configuration procedures, the ASMi-52 units are ready to be connected.

Configuring the Line Interface Type

You can configure the ASMi-52 units with 4-wire interface to operate over 2-wire lines. Selecting the 2-wire operation mode disables pin 1 and pin 2 of the RJ-45 line connector.

To configure the line interface type for ASMi-52 units:

1.From the SHDSL Local Port Configuration menu, select Configured Wire The display is refreshed and a new value appears (2W or 4W).

2.Select Save to save the changes

3.Reset ASMi-52 in order to active the change.

Configuring the Serial DTE Interface

If the ASMi-52 modem is equipped with a serial data interface, the configuration software allows you to enable/disable the LLB/RLB activation from the DTE (except for X.21) and select the modem’s data rate.

Configuring LLB/RLB Activation from DTE

To enable/disable the LLB/RLB activation from DTE:

1.From the DTE Configuration menu, select DTE Local Port Configuration (Main menu > Configuration > DTE Configuration > DTE Local Port) to configure the DTE local port (see Figure 5-5).

The DTE Local Port menu appears (see Figure 5-6).

2.From the DTE Local Port menu, select LLB from DTE to enable the LLB activation from the DTE or select RLB from DTE to enable the RLB activation from the DTE.

The display is refreshed and a new value appears.

3.Select Save to save the changes.

ASMi-52

DTE configuration >

Port number (1)

1.DTE local port

2.DTE remote port

>

ESC-prev. menu; !-main menu; &-exit; @-scroll

Figure 5-5. DTE Configuration Menu

5-4 Configuring the ASMi-52 units ASMi-52 Ver. 2.5