RAD Data comm ASMi-52 manual Selecting E1 Framing Mode, To select E1 framing mode

Installation and Operation Manual			Chapter 4 Configuration
	E1	Local Port	ASMi-52
			(G732N)
	1.	Framed mode
	2.	Sync mode	(CCITT(complies with G732))
	3.	CRC-4	(NO)
	4.	Idle code	(ff)
	5.	Time slots assign	(Yes)
	6.	Unit Identical Set
	7.	Number TS for remote E1
	8.	Save
	>
	ESC-prev. menu; !-main menu; &-exit; @-scroll
		Figure 4-32. E1 Local Port Menu
	E1	Remote Port	ASMi-52
			(G732N)
	Framed mode
	Sync mode		(CCITT (complies with G732))
	CRC-4		(NO)
	Idle code		(ff)
	1.	Time slots assign
	2.	Save
	>
	ESC-prev. menu; !-main menu; &-exit; @-scroll
		Figure 4-33. E1 Remote Port Menu

Selecting E1 Framing Mode

Notes • The Framing mode is configurable if one of the conditions below is fulfilled. If the local ASMi-52 is configured as CO,

if the local ASMi-52 is configured as CPE and the remote is not an E1 modem.

•The remote ASMi-52 is configurable if the local is configured as CO and is not an E1 modem

•If Frame Mode is Unframed, then the remaining E1 parameters are disabled.

To select E1 framing mode:

1.From the E1 Local Port menu, select Framed Mode (Main menu > Configuration > E1 Configuration > E1 Local Port > Framed Mode).

The Framed Mode menu appears (see Figure 4-34).

2.From the Framed Mode menu, select Unframed, G732N, or G732S transparent.

The E1 Local Port menu appears.

3.Save the changes.

ASMi-52 Ver. 2.5 Configuring the Physical Ports 4-29