RAD Data comm ASMi-52 Erasing User’s Configuration, Erasing IR-IP Software, Desired positions

Appendix B IR-IP Interface Module Installation and Operation Manual

B.13 Erasing User’s Configuration

The user-defined configuration parameters are stored in the IP router card flash memory. After the user-defined configuration parameters are erased, the IP router card automatically loads the default parameters.

You may want to erase the current configuration parameters:

•Before IR-IP is prepared for operation in a new application.

•When you cannot configure IR-IP because its current LAN-interface IP address and/or the Telnet password, are not known.

To erase the user’s configuration:

1.Turn ASMi-52 off.

2.Set all the four sections of the IR-IP DIP switch (see Table B-2) to ON.

3.Turn ASMi-52 on and monitor the ERR and LINK indicators: they must blink alternately.

4.While ERR and LINK are blinking (within 15 seconds), set sections 1 and 2 of the DIP switch to OFF.

The IP router configuration is erased. During the process of erasing, the

ERR indicator turns on and lights steadily.

Note
	If you do not set sections 1 and 2 to OFF within 15 seconds of power-up, the IP
	router card ignores the setting of all the four sections to ON and starts normal
	operation. In this case, it is recommended to turn ASMi-52 off and then back on.
	To abort the whole operation, turn ASMi-52 off, return all the four-switch section to
	the desired positions, and then turn ASMi-52 on again.
	5. Turn ASMi-52 off, and then return all the four sections of the DIP switch to the
	desired positions.

B.14 Erasing IR-IP Software

You may erase the IR-IP application software, without erasing the user-defined parameters.

After the application software is erased, IR-IP starts its TFTP server application, and waits for the downloading of software by a TFTP client connected to its LAN interface. The procedure to be used to download the application software in this case is also described below.

You may want to erase the application software if the downloading of new software using the Device Control menu (see Figure B-15) fails, and the IP router card does not function properly.

B-28 Erasing IR-IP Software ASMi-52 Ver. 2.5