RAD Data comm ASMi-52 manual Using the Ping Function, To ping a host

Installation and Operation Manual Appendix B IR-IP Interface Module

Using the Ping Function

The Ping option is used to confirm IP connectivity by pinging other IP hosts. Connectivity is confirmed by receiving a reply from the remote (pinged) IP host.

To ping a host:

1.From the Diagnostic Tools menu, type 1 and enter the desired host IP address.

2.Press <Enter> to confirm the destination IP address.

3.To start pinging, type 2 on the Diagnostic Tools screen.

After pinging starts, you can monitor the ping status. A typical screen is shown in Figure B-25.

Note After pinging is started, it continues in the background even if you exit the Diagnostics Tools screen. In this case, a Ping Running message appears in the top upper left-hand corner of the screen.

4. To stop pinging, type 3 from the Diagnostic Tools menu.

A Ping Stopped message is displayed.

To clear the message and return to the Diagnostic Tools screen, press any key.

IR_IP<IR-IP>S/W Ver. 1.21 (date)

Quick Setup Management Access Advanced Setup Device Control View

Diagnostic Tools (PING terminal)

=====================================================================

1.	Ping IP Address	:192.168.100.011
2.	Start Pinging	:>>>
3.	Stop Pinging	:>>>
Pinging 192.168.212.001 Sent 27 Recvd 25 Lost 2		Resp.Time 60 ms
Press one of the numbers to select or ESC:

Figure B-25. Diagnostic Tools Menu after Receiving Pinging Response

ASMi-52 Ver. 2.5 Using Diagnostic Tools (Ping Terminal) B-27