RAD Data comm ASMi-52 manual Configuring the DTE Interface Data Rate, To select the data rate

Installation and Operation Manual Chapter 4 Configuration

Configuring the DTE Interface Data Rate

ASMi-52 supports multiple data rates between the range of 64 kbps and

4608 kbps, depending on the clock mode and line/DTE interface of the local and remote units (see Table 1-2and Table 1-3).

To select the data rate:

1. From the DTE Local Port menu, select Data Rate.

The Data Rate menu appears (see Figure 4-31). The ASMi-52 screen in Figure 4-31is with a 2-wire, internal clock configuration.

2.Select the data rate by typing the number corresponding to the required value, and press <Enter>.

The DTE Local Port menu appears.

3.Select Save to save the changes.

Data Rate (384 Kbps)				ASMi-52
			13.	832 Kbps		25.	1600	Kbps
1.	64 Kbps
2.	128	Kbps	14.	896 Kbps		26.	1664	Kbps
3.	192	Kbps	15.	960 Kbps		27.	1728	Kbps
4.	256	Kbps	16.	1024	Kbps	28.	1792	Kbps
5.	320	Kbps	17.	1088	Kbps	29.	1856	Kbps
6.	384	Kbps	18.	1152	Kbps	30.	1920	Kbps
7.	448	Kbps	19.	1216	Kbps	31.	1984	Kbps
8.	512	Kbps	20.	1280	Kbps	32.	2048	Kbps
9.	576	Kbps	21.	1344	Kbps	33.	2304	Kbps
10.	640	Kbps	22.	1408	Kbps	………….		Kbps
11.	704	Kbps	23.	1472	Kbps	72.	4608
12.	768	Kbps	24.	1536	Kbps
>

ESC-prev. menu; !-main menu; &-exit; @-scroll

Figure 4-31. Typical Data Rate Menu

Configuring the Data Rate in a Multiplexer Unit

The maximum multiplexer rate is 2048 kbps (general rate). The sum of the data rate of two interfaces should not exceed 2048 kbps.

ASMi-52 is a multiplexer modem with two interfaces that has the following maximum rate for Serial DTE interface:

•If DTE Serial + E1 interface, then the DTE Serial maximum rate = 2048 kbps

– used TSs (timeslots) x 64 kbps.

•If DTE Serial + LAN interface, then the DTE Serial maximum rate = 2048 kbps – LAN rate.

ASMi-52 Ver. 2.5 Configuring the Physical Ports 4-27