RAD Data comm ASMi-52 manual Configuring Aging Timeout, Configuring QoS Mapping, Management

Installation and Operation Manual Chapter 4 Configuration

ASMi-52

Bridge Table

Type(Static)

1.MAC Address ... (00000000000)

2. Port ... ()

>

ESC-prev. menu; !-main menu; &-exit; ?-help

Figure 4-12. Bridge Table, Editing Mode

Configuring Aging Timeout

The aging time is the timeout period in seconds for aging out dynamically learned forwarding information. When the timeout period is over, the bridge removes all inactive nodes from its database.

To configure aging timeout:

1.From the Local LAN Configuration menu, select Aging Timeout (Main menu > Configuration > LAN Configuration > Local LAN Configuration > Aging Timeout).

The LAN Rate menu appears.

2.Enter a new aging timeout value in seconds and press <Enter>.

3.Select Save to save the change.

	Configuring QoS Mapping
	The QoS mapping or the so-called VLAN priority feature prioritizes transmission
	information according to traffic class. VLAN priority is based on a table of 8
	integers (0 to 8) that maps evaluated user priority (see Figure 4-13). Each integer in
	the table handles up to four levels of priority and transmits information to the DSL
	line according to these priorities (see Figure 4-14). This feature is supported in the
	multiplexer unit and in old LAN units.
Note
	•
	This QoS mapping or VLAN Priority feature is different from the VLAN Priority under
	Management
	To configure VLAN Priority (QoS Mapping):

1.From the Local LAN Configuration menu, select QoS Mapping (Main menu > Configuration > LAN Configuration > Local LAN Configuration > QoS Mapping).

2.Select a User Priority number from the menu, (see Figure 4-13).

The User Priority (Traffic Class 0) menu appears (see Figure 4-14).

ASMi-52 Ver. 2.5 Configuring ASMi-52 for Management 4-9