Installing the CPU

When installing a CPU you must mount it onto a wall or a ceiling. You must locate the CPU at a distance from the antenna that is no farther than the cable will allow. The cable length is a maximum of 15 feet; this means you must consider all bends in the cable when determining your distance.

You must also locate the CPU in an area from which it has access to local network cabling and electricity. Before selecting an electrical outlet for use in powering the CPU, verify that the electrical outlet is non-switched (for example, it is not attached to a wall switch). You should also consider placing the CPU in a location where it is out of reach of the general public.

FCC regulations require that this device be professionally installed by a person knowledgeable in electronics and trained in the correct installation of this device.

All interface cables must be shielded.

Tools You Will Need

To install the CPU, you will need the following tools: drill, drill bit, screwdriver, screws, pencil, measuring tape.

890-007 Rev. A 01/28/99

Page 15

© 1999 RadioLAN, Inc.

Page 25
Image 25
RadioLAN Campus BridgeLINK manual Installing the CPU, Tools You Will Need