Ricoh AP3800C operating instructions Error & Status Messages on the Control Panel

Error & Status Messages on the Control Panel

Messages/Second messages	Description	Solution
Close Right Cover	The right cover is open.	Close the right cover.
Close Upper Left Cover	The upper left cover (the cov-	Close the upper left cover.
	er for the fusing unit) is open.
Driver Setting Error (Memo-	The printer identified a down-	Verify that the paper memory
ry)	load error. This error may oc-	size is specified with the driv-
	cur when the installed	er setting.
	memory amount is less than
	the driver setting.
Duplex Cancelled	The setting of Duplex Print	(a) To print the image correct-
	has been cancelled.	ly, add memory to the printer.
		(b) Be sure to use the correct
		paper.
Error:Tray 1 Reset The Job	There is a problem with the	Reset the job then turn the	4
/Then Power OffOn	current specified tray. The job	printer Off, and then back On.
	can not be processed.
Error:Tray 1 Form Feed	The printer identified the fail-	Apply Form Feed from other
/Or Job Reset Then Power Of-	ure of the indicated paper	tray or cancel the job, and then
fOn	tray. The job is not printed.	switch your printer Off then
		back On. If the error contin-
		ues, contact your sales or serv-
		ice representative.
Exceeded Max. Pages (Col-	The printer identified a colla-	Increase the RAM capacity.
late)	tion page overflow error.
		Install the optional hard disk
		drive.
Exceeded Max. Stored Files	The maximum number of	Delete the stored files.
	stored files has been exceeded
	during Sample Print of
	Lacked Print.
Exceeded Max. Stored Pages	The maximum number of	Reduce the number of pages
	pages has been exceeded dur-	to print.
	ing Sample Print of Lacked
	Print
Hardware Problem DIMM	The printer identified a DIMM	Remove and re-install the
	sum value error.	DIMM correctly.
		Remove any dust under the
		DIMM.
		If the message appears again,
		contact your sales or service
		representative.
		See "Setting Up" in the Setup
		Guide.
Hardware Problem Ethernet	The printer identified an Eth-	Turn the power switch off and
	ernet error.	then on. If the message ap-
		pears again, contact your sales
		or service representative.

71