NOTE: Your printer cannot automatically detect the size of paper loaded in the
6In Ready mode, press the Menu button (
) until you see “Paper” on the bottom line of the display.
7Press the Enter button (
) to access the menu.
8Press the scroll button (
or 
) until “Media Size” appears on the bottom line.
9Press the Enter button (
) to access the menu.
10Press the scroll button (
or 
) until the size of paper you loaded appears on the bottom line of the display.
11Press the Enter button (
). Now, you are ready to print.
12When you print a document, set the paper source and type
in the software application. For details, see the Software Section.
For information about setting on the control panel, see page 3.2.
13After printing, put the extender back to its place.
14Close the
Using the Manual Feed Mode
You can manually load a sheet of print material in the Multi- Purpose Tray if you select Manual Feed in the Source option from the Paper tab when you change print settings to print a document. For details about changing print settings, see the Software Section. Manually loading paper can be helpful when you want to check the print quality after each page is printed.
This loading procedure is almost the same as the procedure for loading in the 
) on the control panel to print each following page.
1Load a sheet of print material on the center of the Multi- Purpose Tray with the print side up.
2Squeeze the paper width guide and slide it to the edge of the print material without causing it to bend.
NOTE: When the
3
4
5
When you print a document, set the paper source to
Manual Feed and select the appropriate paper size and type in the software application. For details, see the Software Section.
Print a document.
The display shows a message prompting you to load paper and press the On Line/Continue button (
).
Press the On Line/Continue button (
).
The printer picks up the print material and prints. After one page is printed, the message appears again.
