SECTION 2: INSTALLATION
Under2.2.2OPTION:certain circumstances,UsingAPaperinsteadTubeoftousingWindtheUsedGT printer’sRibbonribbon
1 Lift up the main cover and push the purple head | Replacement |
release lever downwards. The print head assembly | |
will be lifted up. |
|
Insert the carbon ribbon in the ribbon feeder and push it inwards all the way. Insert the paper tube into the new ribbon
3.Pass the carbon ribbon from the ribbon feeder under the print head to the paper tube on the ribbon
4.Check from sideways that the carbon ribbon is set as shown in the following picture.
5.Now remount the print head by pushing down on the head lock lever. The print head should lock into place firmly. You can now proceed to load labels or other media as described in the following sections.
Paper tube
Ribbon feeder
Paper tube
Print head
Paper tube
Print head
Label loaded
•WhenCautionreplacing ribbons, bear in mind that the print head and its
surrounding area remain hot. Keep your fingers away from these areas to prevent injury.
•Avoid touching even the edge of the print head with your bare hands.
Page | GT Series Operator’s Manual |