Sharp FO-DC500 operation manual Entering and Using Programs, Mode is selected and press

Entering and Using Programs

Entering and Using Programs

If you frequently perform the same operation involving the same party, you can program all the steps of the operation into one Program Key. This allows you to perform the operation by simply pressing that key.

♦Any Rapid Key which is not already programmed as a Rapid Key or a Group Key can be used as a Program Key. You can include a timer setting in the program to have the operation performed automatically at a selected time.

♦If the network scanner option is installed, an e-mail, FTP, or Desktop destination can be selected. (This is not possible if a timer setting is included.)

♦To clear a mistake in the procedures that follow, press .STOP

Initial procedure

To program a Program Key, first perform the following procedure. After you have completed this procedure, go to the procedure for the specific operation you want to program (see the following pages).

1 Press MENU and then or

until PROGRAM/GROUP MODE is selected in the display.

MENU MODE 2:LISTING MODE 3:ENTRY MODE 4:OPTIONAL SETTING 5:PROGRAM/GROUP MODE

2

3

START/		PROGRAM/GROUP MODE
			1:PROGRAM ENTRY MODE
Press ENTER .
			2:GROUP ENTRY MODE
Make sure that PROGRAM ENTRY			PROGRAM ENTRY MODE
			1=SET
MODE is selected and press	START/		2=CLEAR
	ENTER .

4 Make sure that “SET” is selected and

START/

then press ENTER .

PROGRAM SET PRESS PROGRAM KEY

166