Sharp FO-DC500 operation manual Setting the IP Address, Press

Setting the IP Address

Setting the IP Address

Once your dealer has installed the network scanner option and the machine is connected to the network, the network administrator or administrator of the machine should use the following procedure to set the IP address of the machine.

Note: Although “DHCP” is available as a setting for the IP address (this means that the machine automatically obtains an address from a DHCP server), it is recommended that a permanent IP address be assigned to the machine. If DHCP must be used, it is recommended that the DHCP lease time for the IP address be set to unlimited. To check the IP address currently assigned to the machine when DHCP is used, print out the network setting list as explained on page 78.

3. Network Scanner

1 Press MENU and then or

until NETWORK SETTING is selected in the display.

Display:

MENU MODE 5:PROGRAM/GROUP MODE 6:SERIAL POLLING MODE 7:MEMORY POLL MODE 8:NETWORK SETTING

2	Press	START/		NETWORK SETTING
		ENTER .		1:NETWORK CONFIG SET
	• Make sure that NETWORK CONFIG			2:SCAN TO E-MAIL SET-UP
				3:NETWORK SETTING LIST
3	SET is selected.
	Press	START/	NETWORK CONFIG SET
		ENTER .		1:IP ADDRESS SETTING
	• Make sure that IP ADDRESS SETTING			2:INITIALIZE THE NIC
	is selected.
4	Press	START/	IP ADDRESS SETTING
				ENABLE DHCP
		ENTER .
				1:YES
				2:NO

75