Sharp FO-DC500 operation manual Setting the Date and Time, Until DATE&TIME SET is selected

Setting the Date and Time

Setting the Date and Time

The date and time appear in the display, in reports, and at the top of each page you transmit. Set the date and time by pressing the keys on the operation panel as shown below.

1. Installation

1 Press MENU and then or

until ENTRY MODE is selected in the display.

Display:

MENU MODE 1:RECEIVE MODE 2:LISTING MODE 3:ENTRY MODE

2	Press	START/	and then	or	ENTRY MODE
		ENTER			01:DESTINATION SETTING
	until DATE&TIME SET is selected.
					02:PASSCODE SETTING
					03:OWN PASSCODE SET
					04:DATE&TIME SET
3	Press	START/			DATE&TIME SET MODE
		ENTER .		The currently	01-10-2004
				set date and	TIME 11:35 AM
				time appear

4 Enter a two-digit number for the month (“01” for January, “02” for February, “12” for December, etc.).

Example: March 0 3

•To correct a mistake, press to move the cursor back to the mistake and then enter the correct number.

5 Enter a two-digit number for the day (“01” to “31”).

Example: The 5th 0 5

27