Sharp FO-DC500 operation manual 140, Once

START/

ENTER

Broadcasting

4

5

• Press e-mail , enter an e-mail address, and then press . (Only if the

network scanner option is installed; maximum of 20 full addresses.)

Note: If you need to delete a destination, press or to select the

STOP

destination and then press .

Note: Scan to FTP and Scan to Desktop destinations cannot be selected.

START/

Press ENTER .

If desired, press RESOLUTION and/or CONTRAST to set the resolution and contrast.

6 If you are sending the document to only fax destinations, press		START/
		ENTER
twice. Transmission will begin.
If e-mail recipients are included in the destinations, press	START/	once
	ENTER

and go to the following step.

7 If you are sending the document to e-

mail destinations, the display at right will appear to let you adjust the e-mail settings. To adjust a setting, press

or to select the setting and

START/

then press ENTER (see Step 6 on page

88 for information on adjusting the settings). Note that if you don’t select a file format, the format selected in SCAN TO E-MAIL SETUP (page 84 and following) is used.

When you are ready to send the document, select “START SCANNING”

START/

and press ENTER .

Display when e-mail recipients have been selected:

1:START SCANNING 2:FROM

XXX

3:FILE FORMAT XXX

4:MESSAGE

NO MESSAGE

Note: If fax destinations have also been selected, the selections for the file format are “TIFF-G4” and “PDF-G4” (G3 cannot be used).

140