Sharp FO-DC500 operation manual 197, Setting 28 Distinctive Ring, Setting 29 Verification Stamp

Optional Settings

Setting 28: DISTINCTIVE RING

This sets the ring pattern to which your fax will answer if you subscribe to a

distinctive ring service. Press or to select a ring pattern and then

START/

press ENTER . See page 187 for more details.

♦Initial setting: OFF

Setting 29: VERIFICATION STAMP

Select ON if you want the machine to stamp each original document page as it is scanned. After scanning, you can check to see if all pages have been stamped to verify that no double feeds occurred. Select OFF to turn the

function off. Press	or	to make the selection and then press	START/
			ENTER .

Note: To use this function, your dealer must install the Verification Stamp option.

♦Initial setting: OFF

Setting 30: DEFAULT COPY RESOLUTION

Use this setting to select the default copying resolution (the resolution used for

copying if a setting is not made with RESOLUTION ). Press or to select

START/

STANDARD, FINE, SUPER FINE, or ULTRA FINE, and then press ENTER .

♦Initial setting: FINE

Setting 31: SEPARATE MODE

If desired, you can have the machine draw a sheet of paper from one of the paper sources after each fax reception (and after each print job if the network printer option is installed). By loading colored (or large) paper in that source, each colored sheet drawn will act as a separator that makes it easy to distinguish where one multi-page document ends and another begins. A Transaction Report printed after a fax reception will also be printed from that

paper source to act as a separator sheet. To turn on this function, press

or to select YES, select the paper source for the separator paper, and

START/

then press ENTER . After turning on the function, be sure to load appropriate

paper in the selected paper source. To turn off Seperate mode, press or

7. Optional Settings

197