Sharp FO-DC500 operation manual Until the desired setting is selected

START/

ENTER

Verification Stamp Option

3 Press and then or

until the desired setting is selected.

•Note: “TX” stands for “transmission” and “RX” stands for “reception”. “AUTO” and “MANU” indicate AUTO and MANUAL reception modes.

Settings for Line 1:

LINE 1 SETTING 1=TX AND RX (AUTO) 2=TX AND RX (MANU) 3=RX (AUTO) ONLY 4=RX (MANU) ONLY

Settings for Line 2:

LINE 2 SETTING

1=TX AND RX (AUTO) 2=TX ONLY

3=RX ONLY

4 START/

Press ENTER .

STOP

5 Go back to Step 3 to select a setting for the other line, or press to exit.

Verification Stamp Option

When transmitting a document, you can have the machine stamp each document page as it is scanned. After scanning, you can check to see if all documents have been stamped to verify that no double feeds occurred. (A double feed occurs when two pages are fed through the scanner at once, which means that one of the pages is not scanned.)

To use this function, have your dealer install the Verification Stamp option, and then set Option Setting 29 to ON as explained on page page 197.

70