Sharp FO-DC500 operation manual

JOB STATUS

Setting the IP Address

11 Wait while the machine writes the setting to the NIC board (“DO NOT POWER DOWN” will appear in the display). When the display changes to “OK”, turn off the power of the machine and then turn it back on to make the new settings take effect. (Before turning off the power, make sure the machine is not in the middle of a job: 1) check whether the machine

is printing, and 2) press and check the display to see if the machine is sending or receiving a fax.)

Initializing the network interface board

Normally the network interface board (NIC) does not need to be initialized (returned to the factory default settings). In the event that you do need to initialize the board, follow the Steps 1 to 3 of the previous procedure to access

“NETWORK CONFIG SET”, press to select “INTIALIZE THE NIC”, and

then press	START/	. Press	to select “YES” and then press	START/	. Wait
	ENTER			ENTER

while the machine writes the setting to the NIC board (“DO NOT POWER DOWN” will appear in the display). When the display changes to “OK”, turn off the power of the machine and then turn it back on to make the new setting take effect. (Before turning off the power, make sure the machine is not in the middle of a job: 1) check whether the machine is printing, and 2) press

JOB STATUS and check the display to see if the machine is sending or receiving a fax.)

3. Network Scanner

77