lWhenreplacing the projectorlamp module:
oPut the projectorinto Standby modeand wait 30 minutes for the lamp to cool
completely.
oDo not removeany screws othert hanthose specified in the lamp replacement
instructions.
oWearprotective eyewear while changingthe lamp module. Failureto do so can cause
injuriesincluding loss of eyesight if the lamp shatters or bursts.
oUse only replacementlamp modulesapproved by SMARTī€ƒTechnologies.Contact your
authorizedSMART reseller for replacementparts.
oNeverreplace the lamp modulewith a previously used lamp module.
oAlways handlethe fragile lamp assembly with care to prevent prematurelamp failureor
exposureto mercury. Use gloves when touching the lampmodule. Do not touch the
lampwit h yourf ingers.
oRecycle or dispose of the lampmodule as hazardousw aste in accordancewith local
regulations.
Youneed a Phillips No. 2 screwdriver and a flat screwdriver to completet heseprocedures.
gTo remove theold l amp module
1. Presst hePower button twice on the remote controlor the ECP to put the projectorinto
Standbymode.
2. Wait at least 30 minutes for the projectorto cool down.
3. Disconnect the power cable from theprojector.
CH A P T E R 5
Maintainingyour interactive whiteboard system
38