Thesecommands control the appearance of your source.These settings are unavailablewhen the
projectoris in Standbymode or whenthe source is disconnected.See Value-basedcommand
methods onpage71 for setting absolute andadjustment commands.
Command Commandtarget range Response
set displaymode[target] =SMARTpresentation
=brightroom
=darkroom
=sRGB
=User
displaymode=[target]
set brightness[v alue] =0 to =100 brightness=[value]
set contrast [value] =0to =100 contrast=[value]
set whitepeaking[value] =0 to = 10 whitepeaking=[value]
set degamma[value] =0 to = 3 degamma=[value]
set red[ value] =0 to =100 red=[value]
set green[value] =0 to =100 green=[value]
set blue[ value] = 0 to =100 blue=[value]
set cyan [value] =0to = 100 cyan=[value]
set magenta[value] =0 to =100 magenta=[value]
set yellow [value] =0 to =100 yellow=[value]
set videofreeze[target] =on
=off
videofreeze=[target]
set cc [target] =cc1
=cc2
=off
cc=[target]
NN OT E
Typically, cc1displays English (U.S.) s ubtitles, while cc2 displays otherregionall anguages, such
as Frenchor Spanish, dependingon television channelor media setup.
Additional VGA sourcecontrols
YourVGA source supports all the generalsource controls describedin Generals ourcecontrols on
previouspage, as well as the commands listed in this section. These settings are unavailablewhen
theprojector is in Standby mode orw henthe VGA s ourcesare disconnected.
NN OT E
Someof t hesecommands are invalid with HDMI input and Composite video sources, andwill
returnthe response“invalidcmd=[command]”.
AP P E N DI X B
Remotelymanaging your systemthrough anRS-2 32 serial interface
74