Thesecommands inform you of the currentsy stem settings. These commands areavailable even
whenthe projector is in Standby mode.
Command Response
getlamphrs lamphrs=[currentlamp hoursof operation]
gets yshrs syshrs=[currentprojector hours of operation]
getf wverddp fwverddp=[currentprojectorfirmware version]
getf wvernet fwvernet=[current networkf irmwareversion]
getf wvermpu fwvermpu=[currentprocessorfi rmwareversion]
getf wverecp fwverecp=[currentE CP firmware version]
getv gaoutnetenable vgaoutnetenable=[current]
gets ignaldetected signaldetected=[trueor false]
getusb1source usb1source=[Video sourceassociated wit h the USB 1 connector on
theEC P]
getusb2source usb2source=[Video sourceassociated wit h the USB 2 connector on
theEC P]
Thesecommands control the currentsy stem settings. These commandsare unavailablew henthe
projectoris in Standby mode. See Value-basedcommandmethods on page 71 for setting absolute
andadjustment commands.
Command Command target range Response
set autosignal[target] =on
=off
autosignal=[target]
set lampreminder[target] =on
=off
lampreminder=[target]
set highbrightness [target] =on
=off
highbrightness=[target]
set autopoweroff[value] =0 to =240 autopoweroff=[value]
set zoom [value] =0 to =30 z oom=[value]
set projectorid[value] =0 to =99 projectorid=[value]
set hposition[v alue] =0 to =100 hposition=[value]
set vposition [value] =-5 to =5 vposition=[value]
set aspectratio[ target] = fill
=match
=16:9
aspectratio=[target]
set projectionmode[target] =front
=ceiling
=rear
=rearceiling
projectionmode=[target]
AP P E N DI X B
Remotelymanaging your systemthrough anRS-2 32 serial interface
78