Audiocontrols
Thesecommands control your projector’sinternal audioamplifier, which affects soundpassed
throughthe projectorto your external audiosy stem (not included).Audio output controlsaren’t defined
by the videos ource.These settings are unavailablewhen the projectoris in Standby mode.
Thesecommands inform you of the currentaudio output settings.
Command Response
getv olume volume=[current volumesett ing]
getmute mute=[currentmute setting]
getv olumecontrol volumecontrol=[currentvolume control setting]
Thesecommands control your projector’saudio amplifiersett ings. See Value-basedcommand
methods onpage71 for setting absolute andadjustment commands.
Command Commandtarget range Response
set volume [value] =-20to =20 volume=[value]
set mute [target] =on
=off
mute=[target]
set volumecontrol[target] =on
=off
volumecontrol=[target]
Networkcontrols
Thesecommands control your projector’snetwork status and settings. These settings are located in
theOSD, and areavailable even when the projectoris in Standby mode. You must locally set the
networkand VGA out commands to on for the network abilities to work.
Thesecommands inform you of the currentnetwork settings.
Command Response
getnetstatus netstatus=connected
netstatus=disconnected
netstatus=disabled
getdhcp dhcp=[currentD HCP status]
getipaddr ipaddr=[currentIP address]
gets ubnetmask subnetmask=[currentsubnet mask number]
getgateway gateway=[currentnetwork gateway]
getprimarydns primarydns=[currentprimary domains erver]
getmacaddr macaddr=[currentMAC address]
AP P E N DI X B
Remotelymanaging your systemthrough anRS-2 32 serial interface
76