>set brightness vga1-7
brightness vga1=58
Powerstate controls
Thesecommands put the projectorin and out of Standby mode andrequest the projector’scurrent
powerstate. The projector’s power state determineswhether certain commandsare availableat that
time. Theses ettings areavailable even whent heprojector is in Standby mode.
Command Response
on powerstate=[field]
off powerstate=[field]
off now powerstate=[field]
getpowerstate powerstate=[field]
Thefollowing table describes the powerst ate commands:
Command Description
on Turnson the projector.
off Starts the shutdown process. A dialogbox appears with the
message,“Press Power Button to Turn off Projector.” You must send
as econdOff command within 10 secondst o put theprojector into
Standbymode.
off now Shuts down the projectorimmediately. You can’t delay or cancel this
command.
getpowerstate Indicatesthe projector’s currentpower state.
Thefollowing table describes the powerst ate fields:
Field Description
Powering The projectoris turning on.
On Theprojector is on.
Cooling Theprojector is cooling.
Confirmoff Confirm off is a non-selectablepowerstate that is returnedduring
stageone of the two-button Off sequence.
Idle Theprojector is off but still receiving power (Standbymode).
Sourceselection controls
Thesecommands switch input sources.The source typedetermines which commandscan be
accepted.
Command Response Availablei n Standby
mode
getinput input=[field] Yes
set input=[field] input=[field] No
AP P E N DI X B
Remotelymanaging your systemthrough anRS-2 32 serial interface
72