gTo put the newl amp module into theprojector
1. Remove the new lamp modulefrom its packaging.
2. Carefully place the lamp moduleinto the projectorusing the handle ont hetop of t hemodule.
Holdt helamp module vertically and guideit into it s slot. Gently press the power endof the
lampmodule against the projectorto ensure the powerplug makes contact with t heprojector’s
powerreceptacle.
NN OT E
Youshould be able to place thelamp module into the projectoreasily wit houtapplying much
force.
3. Use the Phillips sc rewdriverto secure the captive screws.
II M P O R TA N T
Do not over-tightenthe screws.
4. Carefully replacet helamp cover.
5. Connect the power cableto t hew all outlet.
6. Presst hePower button once on theremote control or ECP to confirm that the projector is
operatingandthat t helamp module is correctly installed.
7. Put the old lamp modulein a secure container, andhandle it gently until you recycle it.
gTo finish the projectorlamp module installation
1. Turn ont heprojector.
2. Adjust the projector imageif necessary (seeA djustingthe image on page 23).
3. Access the service menu to reset the lamphours (see Resetting the lamp hours onnext page).
CH A P T E R 5
Maintainingyour interactive whiteboard system
40