Charging and installing the battery pack

Before using your digital camcorder, you first need to charge and install the battery pack. To charge the battery pack, use the supplied AC- V625 AC power adaptor.

This digital camcorder does not interface with “InfoLITHIUM” batteries. The remaining time (minutes) indication does not appear when using “InfoLITHIUM” batteries.

Charging the battery pack

Charge the battery pack on a flat surface without vibration.

(1) Connect the mains lead to the AC power adaptor.

(2) Align the surface of the battery pack indicated by the z mark with the edge of the terminal shutter of the AC power adaptor. Then fit and slide the battery pack in the direction of the arrow.

(3) Connect the AC power cord to the mains. The CHARGE lamp (orange) lights up. Charging begins.

When the CHARGE lamp goes out, normal charge is completed. For full charge, which allows you to use the battery longer than usual, leave the battery pack in place for approximately one hour. Unplug the unit from the mains, then remove the battery pack and install it into the digital camcorder. You can also use the battery pack before it is completely charged.

Carga e instalación de la batería

Antes de utilizar su videocámara digital, tendrá que cargar e instalar la batería. Para cargar la batería, utilice el adaptador de alimentación de CA AC-V625 suministrado.

La videocámara digital carece de interfaz para baterías “InfoLITHIUM”. Cuando utilice baterías “InfoLITHIUM”, no aparecerá la indicación del tiempo restante (minutos).

Carga de la batería

Cargue la batería en una superficie plana exenta de vibraciones.

(1) Conecte el cable de alimentación al adaptador de alimentación de CA.

(2) Alinee la superficie de la batería, indicada con la marca z, con el borde del obturador de terminales del adaptador de alimentación de CA. Después encaje y deslice la batería en el sentido de la flecha.

(3) Conecte el adaptador de alimentación de CA en un tomacorriente. Se encenderá la lámpara CHARGE (anaranjada). Se iniciará la carga.

Cuando se apague la lámpara CHARGE, habrá finalizado la carga normal. Para realizar la carga completa, que le permitirá utilizar la batería más tiempo del normal, déjela así durante aproximadamente una hora. Desenchufe el adaptador de alimentación de CA del tomacorriente, quite la batería, e instálela en la videocámara digital. Usted también podrá utilizar la batería antes de que se haya cargado completamente.

Preparativos started Getting

123

CHARGE

9