Sun Microsystems CP3260 manual Materials and Tools Required, Preparing for the Installation, page

2.2Materials and Tools Required

This section provides information on the materials and tools required to perform installation. The minimum tools required to perform installation are:

■Phillips screwdrivers, No. 1, No. 2 (optional)

■Antistatic wrist strap

■Terminal console

See Section 1.6.1, “Hardware Requirements and Options” on page 1-14 for information on hardware requirements.

2.3Preparing for the Installation

Prepare for installation by reading and performing the following steps:

1.Become familiar with the contents of the documentation referenced in the steps.

2.Verify that all listed hardware and software are available (see Section 1.6, “System Requirements and Options” on page 1-14).

3.Check power, thermal, environmental, and space requirements (see Section 2.3.1, “Checking Power, Thermal, Environmental, and Space Requirements” on

page 2-3).

4.Verify that local area network (LAN) preparations are completed (see

Section 3.3.3, “Determining Local Network IP Addresses and Host Names” on page 3-7).

5.Ensure that the host names and their network IP addresses are allocated and registered at the site.

2.3.1Checking Power, Thermal, Environmental, and Space Requirements

Verify that you meet the following requirements:

■Your enclosure specifications support the sum of the specified maximum blade server power loads.

Chapter 2 Hardware Installation 2-3