Sun Microsystems manual Locate the FB-DIMM connectors on the Netra CP3260 blade server

1.Locate the FB-DIMM connectors on the Netra CP3260 blade server.

Select the connectors where you will install the memory module (FIGURE 2-1). If you need to replace an existing memory module with a new module, see Section 2.5.1.1, “To Remove FB-DIMMMemory Modules” on page 2-10for instructions on removing the FB-DIMM module.

2.Remove the FB-DIMM from its protective packaging, holding the module only by the edges.

3.Insert the bottom edge of the FB-DIMM into the bottom of the slot’s hinge-style connector (see ➊ in FIGURE 2-3).

The socket and module are both keyed, which means the module can be installed one way only. With even pressure, push simultaneously on both upper corners of the FB-DIMM until its bottom edge (the edge with the gold fingers) is firmly seated in the connector.

FIGURE 2-3Installing a FB-DIMM Memory Module

Caution – Do not rock the FB-DIMM into place. Ensure that all contacts engage at the same time. You will feel or hear a click when the FBDIMM properly seats in the connector.

2-12Netra CP3260 Blade Server User’s Guide • April 2009