2.5.1.1To Remove FB-DIMM Memory Modules
You might need to remove a FB-DIMM module from the Netra CP3260 blade server if you are returning the FB-DIMM module or the blade server for service, or if you are replacing a module with another FB-DIMM module.
Note – Safely store the original factory-shipped FB-DIMM and related FB-DIMM packaging. You might wish to store any removed FB-DIMM in the new FB-DIMM packaging, or use the packaging for service.
To remove a FB-DIMM from the Netra CP3260 blade server, perform the following steps:
1. Take antistatic precautions: attach and electrically ground the wrist strap.
Caution – Always wear a grounded antistatic wrist strap when handling modules.
2.Place the Netra CP3260 blade server on an antistatic mat, or on the blade server’s antistatic bag if you do not have a mat available.
3.For the FB-DIMM you wish to remove, simultaneously pull both FB-DIMM retainer clips outward from the slot (see ➊ in FIGURE 2-2).
4.Grasp the FB-DIMM by the edges, and carefully pull it out of its connector (see ➋ in FIGURE 2-2). A slight rocking motion might be required.
Caution – Take extra care to prevent damage when removing the outer most FB-DIMMs.
5. Place it in an antistatic bag.
2-10Netra CP3260 Blade Server User’s Guide • April 2009
