FIGURE 2-2Removing an FB-DIMM Memory Module
6.If you are replacing the module you removed with a new FB-DIMM, install it as described in Section 2.5.1.2, “To Install FB-DIMM Memory Modules” on page 2-11.
2.5.1.2To Install FB-DIMM Memory Modules
The following procedure provides a general guide for installing additional memory. However, for directions on the installation process of the memory FB-DIMMs on the Netra CP3260 blade server, refer to the documentation that shipped with the memory module.
Caution – Do not remove the FB-DIMM from its antistatic container until you are ready to install it on the card. Handle the module only by its edges. Do not touch module components or metal parts. Always wear a grounded antistatic wrist strap when handling modules.
Chapter 2 Hardware Installation 2-11
