
Appendix C: User S ervice
1760 SeriesComponent Waveform/Vector Monitor User Manu al
C-4
CleaningThe instrument should be cleaned often enough to pre vent
dust anddirt from accumulating. Dirt acts asa thermal insu-
lator,preventing effective heat dissipation, and can also pro-
vide high-resistance electrical leaka ge paths between conduc-
tors or components in a humid environme nt.
CAUTION
Do not allow water to get inside any enclosed
assembly or component. Donot cleanany plastic
materials with benzene, toluene, xylene, acetone,
or similar compounds, because they may damage
the plastic.
Exterior
Clean the dust from the outside of the instrument with a soft,
clean cloth or small brush. A brush is especially useful for
removing dust from around the selector buttons, knobs, and
connectors. Hardened dirt can be removed using a soft cloth
dampened witha milddetergent and water solution. Abra-
sive cleaners should not be used.
CRT
Clean the light filter and CRTface with a soft, lint-free cloth
dampened in denatured alcohol. Abrasive cleaners should
not be used.
Interior
Interior cleaning and maintenance shouldbe performed by
qualified service personnel only. Instructions for interior
maintenance are provided in the service manual.