AtA Glance
1760 SeriesComponent Waveform/Vector Monitor User Manu al 2-5
HTIME CODE provides monitoring of longitudinal
time code in a frame-ratedisplay.
HMULTIPLEallows simultaneous selectionof WAVE-
FORM and VECTOR DISPLAY modes.
SWEEP
Sweep buttonsare used to select the waveform sweep rate.
HLINE/FIELD toggles through four sweep rate sele c-
tions: one line, two line, one field, and two fie ld.
Twoline and two field selections not available with
PARADE or A123 or B123 display.
HMAG turns on the sweep magnifier. See page 3-6.
DC REST
HRESTORE turns the DC Restorer on or off. Set DC
restorer speed and clamp point through the CON-
FIGURE menu, shown on page 3-20.
REF
HEXT toggles between external (EXT LE D on) and
internal reference. Internal reference c an be config-
ured for component operation, and two external
reference inputs can be designated for dual-standa rd
instruments. See CONFIGURE menu on page 3-20.
INPUT
HSelecting a front-panel input causes the signal that is
input to the corresponding rear-panel connector to
be displayed on screen.