1760 SeriesComponent Waveform/Vector Monitor User Manu al 3-7
Using the Menus
General menu informationhere is followed by detailed
information about each menu: FILTER, CURSOR, LIN SEL,
PRESET,CONFIG, GAIN and CRT. To set instrument operating
parameters, seeCONFIG and CRT menu information.

General Menu In formation

Push the desired menu button to obtain an on-screen menu
readout.

Multi-Use Bezel Controls and Buttons

Menu selections appear along the right side of the screen.
Descriptivelabels, when present, appear in ITALIC text.Ac-
tual selections appearin STANDARD text,withthe present
selection outlined. Use the five buttons along the rightside
of the CRT (referred to as bezel buttons) to change the selec-
tions.
The center three controls under the CRT are referred to as
Left, Center,and Right bezel controls. Control functions
vary with menu choice; a readout just above e ach active con-
trol shows its present function. These controls are used as
variable analog controls to set values such as phase, ampli-
tude, and intensity. The left cont rol is also used to select
categories withinthe CONFIG menu.
Figure 3-1 shows the bezel controls and buttons.

Moving Between Menus

Selecting a second menu removes the present me nu display,
but the functionstypically remain active (with the menu LED
remaining lightedto show this state). To reinstate a menu
display, push that menu button again.
CRT,PRESET, and CONFIG menus will be exited completel y
when another menu button is pushed.