
Usingthe Menus
1760 SeriesComponent Waveform/Vector Monitor User Manu al 3-13
Vector + Waveform (Multiple)
If MULTIPLE is pressed and both VECTOR andWAVEFORM dis-
plays are selected, menus for a ll cursor types will be dis-
played. See Figure 3-4. All cursor functions are available in
this mode(the top three bezel buttons are self-cancelling).
Bezel control assignmentsare the same as for the individual
modes.
Using the CursorsWith Vector Display
To useve ctor cursors, operate in VECTOR or VECTOR+WAVE-
FORM mode and press the CURSOR MENU button. There are
two vector cursordisplays: POLAR and MARK.(The VECTOR
PHASE bezel controlcontinues to adjust the phase of the sig-
nal.)
Polar Cursorscan be used to measure the a mplitude and
phase of the chrominance signal. When POLAR is selected,
positionthe cursor (cross hairs) with the AMPLITUDE and
PHASE bezel controls,and view the amplitude and phase
readouts at the top of the screen. See Figure 3-2. Whena
component signal is displayed (A 1-2-3 or B 1-2-3), it will be
encoded so that the readout phase and amplitude matches
that of a compositesignal. This feature allowsthe operator
to set component equipment to a specific color phase if the
composite phase value is known.
The cursor zero amplitude point is the cent er point of the
graticule. Using the amplitude control to move the cursor
out from the center increases the amplitude. Adjusting the
cursor phase will rotate the cursor around the center point,
with the zero phase point being the B--Y(U) axis. The am-
plitude readout can be set for mVor IRE values through the
CONFIG menu, described on page 3-20.